Jim77215
2008-07-15 15:40:09 UTC
I have successfully installed a PCI DIO 96 card
and am currently trying to update old 90's software to work with the
hardware. When I tried to load the older sofware LabVIEW 8.5 froze, it
would not load the vi. I finally traced the problem to the sub vi's;
DIO Port Write.vi and DIO Port Read.vi. If I even attempt to put these
vi's on a blank vi diagram LabVIEW freezes. This only happens on the
computer with the DIO hardware. If I use the palette vi's DIO Write.vi
and DIO Read.vi instead the vi loads just fine. Is it ok to substitute
DIO Write.vi for DIO Port Write.vi and DIO Read.vi for DIO Port Read.vi?
and am currently trying to update old 90's software to work with the
hardware. When I tried to load the older sofware LabVIEW 8.5 froze, it
would not load the vi. I finally traced the problem to the sub vi's;
DIO Port Write.vi and DIO Port Read.vi. If I even attempt to put these
vi's on a blank vi diagram LabVIEW freezes. This only happens on the
computer with the DIO hardware. If I use the palette vi's DIO Write.vi
and DIO Read.vi instead the vi loads just fine. Is it ok to substitute
DIO Write.vi for DIO Port Write.vi and DIO Read.vi for DIO Port Read.vi?